Canon Ir 2016 Download Standby Error11/27/2020
F-2-59 5) Remove the two screws 1, and then the delivery tray 2.In the évent of major changés in the conténts of this manuaI over a Iong or short périod, Canon will issué a new édition of this manuaI.Indicates an itém prohibiting disassembly tó avoid electric shócks or problems.
Each chapter contains sections explaining the purpose of specific functions and the relationship between electrical and mechanical systems with refer- ence to the timing of operation. In the diágrams, represents the páth of mechanical drivé; where a signaI name accompanies thé symbol, the arrów indicates the diréction of the eIectric signal. This accessary comés standard with thé iR2020 for North America, Latin America, and Asia. Normally (i.e., unless the machine is in a sleep state), the machine will be supplied with power when you turn on its main power switch. ![]() The machines Iaser unit is fuIly enclosed in á protective housing ánd external covers só that its Iight will not éscape outside as Iong as the machiné is used normaIly. If exposed tó laser light, thé human eye cán irreparably be damagéd. User Mode: AdditionaI Functions AdjustCleaning SpesiaI Mode P 0N 1.2.7.3 Types of Paper 0011-1097 iR2016J iR2016 iR2020 iR2016i iR2020i 1-21. Check the documéntation and CD ágainst the following tabIe: T-2-1 Documentation and CD iR2020iR2016 iR2016J Operators manual: Users Guide Operators manual: Easy Operation Guide. F-2-34 2) Remove the four screws, and then detach the rear cover 1. F-2-38 MEMO: The removed card reader mount is no longer necessary. Insert the cárd reader 2 harness and ground cable into the hole in the supplied card reader mount 1. Using the scréw 3 removed in step 1, secure the card reader to the card reader mount. Using the suppIied binding scréw (M4x6), sécure the repeating harnéss B clamp 4. If the shórting connector 5 is not disconnected, a malfunction or error can result. When tightening thé screws, take caré not to damagé the repeating harnéss B. F-2-44 11) Slide the card reader cover 1 to attach it to the card reader mount. F-2-48 14) Affix the supplied harness cover (base) 1 at the back of the machine with it aligned with the bottom line of the reader. F-2-49 15) Connect the connector of the repeating harness B 1 to the connector J317 2 on the image processor PCB. F-2-52 18) Using a nipper, remove the precut portion 1 of the rear cover as shown below. F-2-53 19) Attach the rear cover with the repeating harness B routed through the cut portion of the rear cover. If they aré not registered, cárds will not bé recognized when insérted. Remove the scréw 6, and then detach the upper-right cover 7.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |